![]() ![]() To setup and use serial connection with Docstar or GoFlex Net & Home via PuTTy in Windows or Screen package in ArchLinux, follow Varkey's Seagate GoFlex Net : Serial Connection or similar Dockstar Guide. Instead, correct your Uboot env to add TFTP server address in Netconsole or after booting to ArchLinux, and then reflash the original kernel via TFTP. If your updated Uboot is intact and works well, you may not need a Serial to reflash a Plug NAND to stock firmware. While Uboot reflash to Pogo bootloader is needed to boot the Pogo stock from NAND, depending on your situation, it may not be required to fix ArcLinux boot or SSH access problems, so it may be enough just to correct Uboot environment via Serial or Netconsole by entering setenv sequence, then saveenv, printenv to verify, and hardware reboot. You may want to try reflashing first with Netconsole over LAN, if you added its support earlier to Uboot environment. ![]() Here are bzboi's instructions on downloading and reflashing the original DockStar's or Jeff's Uboot with Serial cable, which makes this thread complete. If its broken you may want to follow the above Pheenix's success with "normal" Jeff Doozan's Uboot. Since Ubit doesn't support newest ArcLinux releases, many users updated GFN & GFH to Uboot. Pogoplug jffs2 root filesystem on /dev/mtd2 Pogoplug kernel at addresses 0x000000 to 0x300000 on /dev/mtd1Ĥ. Pogoplug U-Boot envrionment at 0xa0000 on /dev/mtd0ģ. Pogoplug U-Boot in the first 512KB of /dev/mtd0Ģ. You can try restoring to stock first via Ubit after booting to the Plug by following the linked nanddump thread and keeping in mind that:Ĭode: Select all Returning to Pogoplug functionality requires that all the Pogoplug components are installed correctly in their proper locations:ġ. While Dockstar uses Uboot for booting, GoFlex Net & Home owners previously replaced original Pogo bootloader with Ubit due to hardware differences. Once you get a new Plug, it may be a good idea to backup its NAND internal memory blocks with nanddump, more examples here. Marvell> Pheenix Posts: 2 Joined: Sun 2:02 pm # JFFS2 LOAD ERROR for uboot-original-mtd0.kwb! # JFFS2 loading 'uboot-original-mtd0.kwb' to 0x800000įind_inode failed for name=uboot-original-mtd0.kwb UBIFS error (pid 0): ubifs_get_sb: cannot open "ubi:rootfs", error -19Įrror reading superblock on volume 'ubi:rootfs'! UBI: number of PEBs reserved for bad PEB handling: 17 UBI: VID header offset: 512 (aligned 512) UBI: logical eraseblock size: 129024 bytes ![]() UBI: physical eraseblock size: 131072 bytes (128 KiB) ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |